–
The permissible value range of numerical values has not been observed.
–
Invalid characters have been entered for numerical values.
–
The minimum or maximum number of characters within a text has not been observed.
Identification of parameters
Some parameters contains identification marks that are displayed to the left of the input and display
panel. Parameters can contain the following identification marks:
Symbol
Explanation
Any changes to this parameter only become effective following reinitialisation of the
device.
The reinitialisation cannot be completed if a parameter, that requires a reinitialisa-
tion, is modified and controller enable is activated.
If controller enable is not activated and a reinitialisation is required, controller enable
cannot be activated.
Any changes to this parameter only become effective once they have been saved and
the device has subsequently been restarted.
Restarting the device includes a reinitialisation.
Modified parameters only remain effective following a restart if they have been saved
beforehand.
Tab. 32 Description of parameter identification marks
2.3.3
Drive configuration
After adding a device from the device catalogue to a project, the page displays "Drive configuration" a
selection list that calls attention to the initial commissioning assistant. The following options are avail-
able:
–
Start initial commissioning assistant.... starts the initial commissioning assistant, which guides
the user through the most important steps in parameterisation
–
Manual commissioning... enables the manual "Drive configuration"
Once an option has been selected, the selection list is no longer offered. The initial commissioning
assistant can be started if required via the button "Start first setup..." in the toolbar.
Using the parameter panel
The "Drive configuration" parameter panel can only be operated if the following prerequisite is met:
–
The plug-in is
not
connected to a device.
The drive components in use are selected and configured in the drive configuration. A drive is fully
configured with the following drive components:
–
Servo controller
–
Motor
–
Axis
–
Mounting kit
One or more gear units can be optionally selected.
Click on a configured drive component to show additional information in the right sidebar, such as
Support:
–
User Manuals
CMMT-ST Plug-in
51
Festo — CMMT-ST-SW — 2019-02
Summary of Contents for CMMT-ST-SW
Page 615: ......
