A
Technical appendix
38
Festo – GDCP-CMMP-AS-M0-S1-EN – 1412a – English
Auxiliary supply 24 V, 0 V – output
Design
Logic supply voltage routed out of the motor controller (fed
in at [X9], not additionally filtered or stabilised). Reserve
polarity protected, overvoltage-proof up to DC 60 V.
Nominal voltage
[V]
24
Nominal current
[mA]
100 (short circuit proof, max 300 mA)
Voltage drop
[V]
1 (for nominal current)
Tab. A.8
Technical data: Electrical data of the auxiliary supply output
Galvanic isolation
Galvanically isolated potential area
STO-A / 0V-A
STO-B / 0V-B
C1 / C2
24 V / 0 V (Logic supply to the motor controller)
Tab. A.9
Technical data: Galvanic isolation
Cabling
Max. cable length
[m]
30
Screening
When wiring outside the control cabinet, use screened
cable. Guide screening into the control cabinet / attach to
the side of the control cabinet.
Cable cross section (flexible conductors, wire end sleeve with insulating collar)
One conductor
[mm²]
0.25 … 0.5
Two conductors
[mm²]
2 x 0.25 (with twin wire end sleeves)
Tightening torque M2
[Nm]
0.22 … 0.25
Tab. A.10
Technical data: Cabling
