Unplug cable
1. Pull the cable with your fingers to unplug the main plug.
2. To RJ45plug, actuate the locking lever.
7.2
Cable installation in the connection shaft
WARNING!
Failure of the emergency stop or the enabling function.
Failure of the emergency stop or enabling functions can result in personal injury and material damage.
•
When plugging in, make sure that the main plug engages correctly.
•
Check the emergency stop and enabling functions before re-commissioning the handheld terminal
CDSA-D3-RV.
•
Check the emergency stop and enabling functions before commissioning the machine or system.
NOTICE!
Incorrect handling when closing the connection shaft.
Incorrect handling can damage the cables and the connection shaft.
•
The seal must be clean, undamaged and in the correct position.
•
Do not pinch the cable.
•
Screw on the cover of the connection shaft with all screws and tighten to a torque of 0.8 to
1.0 Nm.
NOTICE!
Incorrect handling of the plug when working in the connection shaft.
Incorrect handling can damage the plugs and the socket.
•
Do not use sharp objects to remove the plugs.
•
Disconnect the main plug by pulling its wires with fingers.
•
Press the locking lever to disconnect the RJ45 plug.
When the connection shaft is opened, the connecting cables can be positioned as shown in the follow-
ing sections. Before opening the handheld terminal CDSA-D3-RV observe the following instructions:
Information for opening the connection shaft
•
Place the handheld terminal CDSA-D3-RV with the display facing downwards on a flat, clean and
soft base so that the handheld terminal CDSA-D3-RV or its operating elements are not damaged
(e.g. ESD mat).
•
To open and close the connection shaft, use a "TORX size 10" screwdriver.
Mounting and installation
26
Festo — CDSA-D3-RV — 2020-08
