2. Insert USB memory stick until it clicks into place.
Ä
The USB memory stick is recognised and displayed by the operating system.
NOTICE!
Improper removal of the USB memory stick.
Incorrect removal of the USB memory stick can result in data loss.
•
Do not remove the USB memory stick until writing is finished.
Unplug the USB memory stick
1. Remove USB memory stick.
2. Press protective cap firmly down.
6
Transport and storage
–
Maintain ambient conditions
è
13.2 Handheld terminal CDSA-D3-RV.
–
Use the original packing for transport. Also use the original packaging for onward or return trans-
port.
7
Mounting and installation
WARNING!
Risk of injury due to electric shock.
•
Use PELV or SELV power circuits exclusively in accordance with EN 61010-2-201 for the electrical
power supply of the device.
•
Only voltages and circuits that guarantee reliable isolation from dangerous voltages (e.g. by suffi-
cient insulation and dielectric strength) are to be connected to connections, terminals or inter-
faces up to 50 V nominal voltage.
WARNING!
Fire hazard due to component failure.
Injury resulting from fire.
•
Ensure adequate protection of the 24 V DC power supply of the device in the end application. In
addition, use a UL 248-approved fuse with max. 3.15 A.
NOTICE!
Damage to the electronics due to electrostatic discharge.
When opened, the device can be damaged by electrostatic discharge.
•
Do not open the housing of the device. The connection shaft may be opened.
Transport and storage
22
Festo — CDSA-D3-RV — 2020-08
