Festo 8060571, Repair Instructions

Page: 34 / 52

34 / 52 Festo 7ELCC_TB_KFb_en
1. Place the shims (2x) on the holes (2x) for the shafts of the roller mod-
ules (2x) in the end plate.
2. Insert the roller modules (2x) together with the toothed belt pulley module
(in correct position) into the end plate.
3. Place the shims (2x) on the top of the shafts of the roller modules (2x).
4. Clean socket head screws (4x) to remove locking agent.
5. Wet the socket head screws (4x) with locking agent.
6. Align the end plate with roller and toothed belt pulley modules at the spac-
ing bolt (4x) and at the same time, push the shafts of the roller modules (2x)
and the deep-groove ball bearing of the toothed belt pulley module into the
mountings of the slide module.
7. Screw in socket head screws (4x) through the end plate in the spacing bolt
(4x) and tighten to the appropriate tightening torque (  Table), use an
open‑ended spanner to fix the spacing bolt in position.
Type Tightening torque
ELCC-TB-KF-60 6 Nm ± 10 %
ELCC-TB-KF-70 6 Nm ± 10 %
ELCC-TB-KF-90 10 Nm ± 10 %
ELCC-TB-KF-110 23 Nm ± 10 %
10. Mount toothed belt (  Chapter 5.1.2 on page 27 ).
11. Mount the housing on the drive head (

Chapter 5.1.2 on page 27 ).
5.4 Replacing the cover strip
The cover strip is only supplied for cantilever axes with feature P9 .