13
3. Route DC cable type D and DC cable type E through the left
opening in the top of the cabinet and then insert the cable through
the right opening. Also route the AC cable to the control module
through the left opening.
4. Disconnect the pre-assembled adapters from the back of all ESOs
as shown above.
7.3
Installation of battery modules
1. Place the Pylontech SC100 Controller in the compartment at the
top left of the cabinet as shown (disregard the cables). Fasten with
the intended screws in the mounting rails.
2. Place and fasten Pylontech battery modules in the remaining
compartments in the rack cabinet.
Summary of Contents for Pylontech M1
Page 1: ...Installation manual Pylontech M1...
Page 11: ...10...
Page 20: ...Electricity Reinvented...