FERRI ZMLE Series, Use And Maintenance Manual, Page: 62 / 124

62
ZMLE
Rev. 2.0
ADJUSTMENTS
5.1
05-Regolazione altezza di taglio (ZMLE)
Height between roller and maximum
cutting circumference
A
mm 12
in 0,47
B
mm 31
in 1,22
C
mm 49
in 1,93
3
1
4
2
A
B
C
D
5.2 Adjusting the cutting height
Position the tractor on flat ground in order to avoid lateral loading of the machine on
the tie rods. Before adjusting, turn off the engine, put the hand brake on, disengage the
power take-off and remove the ignition key.
CAUTION
Do not work or carry out maintenance operations or repairs under the machine or its
components unless these are securely supported on blocks or supports, in order to
prevent sudden falling of components which could cause serious injury or death.
DANGER
Correct adjustment of the machine working height allows:
► Jobs to be performed in a workmanlike manner;
► Improved performance of the machine - tractor assembly;
► A considerable reduction of wear on the lateral runners (if fitted).
By adjusting the height of the support roller it is possible to vary the cutting height.
The flails must never touch the ground.
CAUTION
To perform adjustment, proceed as follows, on both sides of the flail head:
► Maintain the shredder in a horizontal position and lifted off the ground;
► loosen the screw ( 1 );
► tighten the screw ( 2 ) and the nut ( 3 ).
► depending on the degree of finishing that you want to obtain, align one of the three adjusting holes ( A , B , C ) of
plate ( 2 ) connected to the support roller, to the hole on the frame ( D ).
► tighten the screw ( 2 ) and the nut ( 3 ) in the new position;
► tighten the screw ( 1 ).