60
ZMLE
Rev. 2.0
TRANSPORT AND INSTALLATION
04-Distacco dalla trattrice (trinciatrici)
4.6 Detachment from the tractor
Proceed as follows to uncouple the machine from the tractor:
1)
Apply the tractor parking brake.
2)
Close the arms (for side shredders).
3)
Lower the machine support feet (if present) and lock them into place.
4)
Position the machine on the ground using the tractor hydraulic lifting device.
5)
Switch off the tractor PTO.
6)
Switch off the tractor engine.
7)
Remove the ignition key from the control panel.
8)
Remove the PTO shaft by working on the anti-removal triggers and place it on the corresponding support.
9)
Release the stabiliser of the third point coupling and remove the respective peg and pin.
10)
Fasten the third point coupling to the respective support on the tractor.
11)
Release the hydraulic lifting device arms from the machine coupling points by removing the respective anti-
removal triggers and connection pins.
12)
Get back on the tractor and start the engine.
13)
Drive away carefully.
Summary of Contents for ZMLE Series
