Installing the support spring
1. It is easier to sand the ceiling when the
sanding pad is held at an angle to the handle
by installing the support spring
17
.
2. To install the support spring, hook one end
into the hole in the motor's housing. Fix the
other end to the respective receptacle on the
handle as shown in Fig. 5.
Operation
NOTE!
RECOMMENDATION: The tool should always be
supplied via a residual current device with a
rated residual current of 30 mA or less.
Switching on/off
1. To switch on the product, press and hold the
on/off trigger
12
.
2. To switch off the product, release the on/off
trigger
12
.
Continuous operation
1. The product has a lock-on button for continuous operation without having to
hold down the on/off trigger
12
.
2. Press and hold the on/off trigger
12
to start the product.
3. Press the lock-on button and then release the on/off trigger
12
.
4. To stop the product, press and release the on/off trigger
12
.
5
17
6
5
12
Assembly
16
Summary of Contents for YT-7251A
Page 2: ...Overview 2 8 9 4 10 7 6 5 1 2 3 13 16 11 15 17 12 14...
Page 4: ......
