6
0°
5°
10°
15
° 20°
25
°
30°
35°
3. Tighten the hexagon screw on the device by turning it clockwise.
4. Align the worktable
26
so that it is no more than 1.6 mm away from the sanding
disc
17
and tighten the hexagon screw as shown in the illustration.
7
14
30
5. You can fine-tune the spacing between the worktable and the sanding disc by
loosening the two screws on the underside of the worktable as shown in the
illustration.
6. Gently move the worktable forwards or backwards until the spacing is correct.
7. Tighten both screws by turning them clockwise.
Attaching worktable to belt sander
The worktable
26
can be attached to the belt sander in order to enable
vertical working. First, the work support
18
must first be removed.
Assembly instruction
18
