Kapitelüberschrift
33
Starting the engine when warm
(The equipment has been idle for less than 15-20min)
Fill up the fuel tank with the relevant mixture of petrol and oil (Fig. 7), and also top
up the chain oil (Fig. 7). See the section ‘Fuel and oil’.
1.
Activate the chain brake before starting (Fig. 6/pos 3).
2.
Make sure the stop switch is in the ‘I’ (ON) position (Fig. 8 / pos 19).
3.
Set the equipment down on a firm level flat surface. Hold the saw firmly as
shown. (Fig. 10) Beware of moving chain!
4.
Pull the starter handle rapidly 6 times (Fig. 10/pos. 6). The engine should start.
If the equipment does not start after 6 tugs, repeat the steps of the procedure
for starting the engine from cold.
Each time before use, check the following:
-
That there are no leaks in the fuel system.
SWITCHING OFF THE ENGINE
Emergency Stop procedure:
To stop the engine in an emergency, activate the Chain brake lever / front hand
guard (Fig.6/pos. 3). This will immediately stop the chain. Then switch the stop
switch (Fig. 8/pos. 19) to ‘0’ Stop.
Normal procedure:
Let go of the throttle lever (Fig. 11/pos. 18) and wait until the engine has changed to
idling speed. Then set the stop switch (Fig. 11/pos.19) to ‘0’ Stop.
Practice all the work steps with the engine switched off before you start to use the
equipment.
m
CAUTION
When idling, the saw chain (2) should not move. If the saw chain (2) moves, you need
to adjust the idling speed!
Operation
