16
Assembly
• Only use appliances which are in perfect working order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance. Rated capacity of drum is 64l.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
VII. Assembly
m
ATTENTION! Ensure the machine is correctly and completely assembled before use.
m
CAUTION! The concrete mixer should be used only after it is installed fully.
1. Installing wheels Fig.3 (Accessory bag A)
Install wheels on both sides, washer, wheel (12), washer, split-pin on the supporting stand rear with
wheel axle (11). Bend the longer leg of the split pin away from the shorter, to hold the wheel in place.
2. Installing the front supporting stand with frame Fig.4 (Accessory bag B)
Install front supporting stand (1) with 2 M8x70 screws, 2 8mm washers, 2 lockwashers, 2 M8
nuts on the frame (3) and tighten the screws. Choose the upper setting where the front sup-
porting stand has the same height as the wheel support.
3. Installing the frame with the wheel supports Fig. 5 (Accessory bag C)
Install frame and wheel supports fully with 2 M8x70 hexagon bolts, 2 8mm washers, 2 lock-
washers and 2 M8 nuts. Tighten the screws.
4. Installing the lower section of drum with frame Fig.6 (Accessory bag D)
Set the lower section of the drum (7) with bearing bracket (6) on the pre-installed framework,
tighten with 2 M8x65 hexagon bolts, 2 washers, 2 lockwashers and 2 M8 nuts.
Secure with a Ø42 split-ring.
5. Installing mixer Fig.7 (Accessory bag E)
Lock mixer (9) with 2 M8x20 cross-head screws to the lower section of the drum with each 1
washer, 1 sealing washer, 1 lockwasher and 1 M8 nut. Have a second person hold the mixer in
place while the bolt is tightened.
6. Installing upper section of drum Fig.8 (Accessory bag F)
Place rubber ring on the lower section. Place the upper section of drum on it.
m
ATTENTION! The pasted arrows mark the exact direction of the upper or lower section of
the drum. Align the upper section of the drum and install it on the lower section with 6 M8x16
cross-head screws with washers and tighten. Lock mixer (9) with 2 M8x20 cross-head screws
to the upper section of the drum with each 1 washer, 1 sealing washer, 1 lockwasher and 1 M8
nut. Have a second person hold the mixer in place while the bolt is tightened.
Assembly
