4
CAYMAN LED glass aquariums
GB
RU
PL
DA
SV
HU
CS
SK
ES
NL
D
FR
IT
PT
IMPORTANT WARNINGS
Before performing any operation, please
read the following instructions carefully for your
safety and to prevent damage to the aquarium:
• Ensure that the voltage shown on the all
electrical components corresponds to that of
your home electrical power supply.
• The aquarium is intended only for indoor use.
• Before switching on make sure your home is
protected by an automatic safety breaker switch
(or individual breaker plug) with an operating
current of no more than 30 mA.
• Do not connect the aquarium to the power
supply before correctly completing all the
installation procedures, including filling with
water.
• Always disconnect all appliances from the
electric power supply before carrying out any
maintenance.
• Remember that the protection of the lights
from water and dust is guaranteed only when
the fluorescent tubes are correctly inserted and
the ring nuts perfectly tightened.
• The lights must never be submerged.
• The power cable has Y-type wiring, so if
damaged it must be replaced by a qualified
electrician.
• All special maintenance work must be carried out
by a qualified electrician. ‘Special maintenance’
means any kind of work not included in the
paragraph ‘Maintaining the CAYMAN aquarium’
and ‘Maintaining the BLUWAVE filter’. ‘Qualified
electrician’ means any qualified member of the
register of installer.
• Never remove the heater (if present) from the
water when it is connected to the electric power
supply. Before removing the heater, disconnect
it and leave it to cool inside its housing for at
least 5 minutes.
• Check that the Bluwave filter intake grilles are
not blocked.
• Always ensure that the water level stays above
the minimum level and below the maximum;
both are marked on the front of the BLUWAVE
filter. Remember that the water level should
always be between the MIN and MAX levels,
both shown on the front of the BLUWAVE filter.
• Do not pour liquid onto the overtank lamp
because it contains electrical parts:
• Do not damage the silicone cord with scissors,
pliers, brushes or scrapers;
• Do not use detergents, solvents or chemical
products (descaler, ammonium-based
products, etc.) to clean the glass, as they could
damage the silicone, causing it to become
detached (possibly some time later);
• Do not use adhesives or adhesive tape near the
silicone when applying backgrounds. Moreover,
you should always use a spirit level to make sure
that the aquarium is placed on a perfectly flat
surface in both directions (length and depth), so
as not to break the glass or damage the silicone.
Check that all parts are undamaged (lights, heater, glass and plastic parts,
etc.). Ferplast uses strong, secure packaging and checks each aquarium
individually, but we recommend you also check that no accidental
damage has occurred during transport, storage or sale which could affect
its watertight seal and safe use.
