© Ferno-Washington, Inc. / 234-3449-08 / November 2017
24
6 - MAINTENANCE
6.1 Maintenance Schedule
The transporter requires regular maintenance. Set up and follow a
maintenance schedule. The table at right represents minimum intervals
for maintenance. Also refer to the Recommended Routine Parts
Replacement Schedule on this page.
Keep maintenance records. For a sample record sheet, see “Maintenance
Record” on page 29.
When using maintenance products, follow the manufacturers’ directions
and read the manufacturers’ material safety data sheets.
Maintenance
6.2 Tracker™ (Optional)
The optional Tracker™ device is attached to the undercarriage and
counts transporter cycles. A cycle is recorded each time the transporter
moves from the folded position to a raised position and back. The total
number of cycles is displayed on an LCD readout (Figure 26).
Use the Tracker™ as an aid
to schedule and record
transporter maintenance.
Notee:
The Tracker™ is
designed to maintain a
count of the total number
of transporter cycles. It is not
designed to be reset to zero.
Figure 26 -Tracker™
Minimum
Maintenance
Each Use As Needed Monthly
Disinfecting
(page 25)
•
Cleaning
(page 25)
•
Waxing
(page 25)
•
•
Inspecting
(page 25)
•
Lubricating
(page 26)
•
WARNING
Improper maintenance can cause injury. Maintain the
transporter only as described in this manual.
Recommended Routine Parts
Replacement Schedule
Inspect and replace the transporter parts listed below at the
proper time or cycle count, whichever comes first. To order
kits, see “Parts, Service, and Accessories” on page 27.
AS NEEDED
●
100 mm Loading wheel [190-2034]
●
150 mm Transport wheel [190-2044]
●
Scuff strips [190-2035; 190-2046; 190-2045; 190-2047]
EVERY 3 YEARS OR 15,000 CYCLES
●
Loading-end wheel caster (2) [190-2038]
●
Loading-end swivel-lock pin and spring (2 ea.) [190-2054]
●
Control-end wheel caster w/lock (2) [090-5922]
●
Control-end wheel-lock lever, spring, and paddle (2)
[190-2036]
EVERY 4 YEARS OR 20,000 CYCLES
●
Leg control box assembly (each end) [090-5919]
●
Loading-leg lock spring (2) [190-2043]
●
Center control box assembly [090-5920] *
* If equipped with control-end leg auto-release.