9
© Ferno UK Ltd. FERNO/MAN/02/14/209 UK
Harrier LT / Harrier LT-LBS
5 - USIng THe TRoLLey
Using the Trolley
WARnIng
Always ensure that two operators are with the
trolley at all times
Important
Always ensure the drop down head end frame is in the
raised position before operating the lifting or lowering
mechanism on the trolley
Ensure that the following procedures are complied with:
1. Advise the patient before making adjustments, lifting or
loading the trolley.
2. Stay with the patient and control the trolley at all times.
3. Keep the patient restrained and the cotsides up when using
the trolley.
4. Use help when needed to ensure patient and operator safety.
5.0 Transferring a Patient onto a Trolley
1. Lower the cotside rails.
2. Place the trolley beside the patient and open the restraints.
3. Ensure that the brakes are applied.
4. Transfer the patient onto the trolley using recognised
manual handling procedures.
5. Close the restraints around the patient.
6. Raise the cotside rails.
7. Make adjustments as necessary.
5.1 Using the BioSafe Patient Harness &
Restraints
For the product to fully comply with BS EN 1789:2007, the
patient must be fully restrained using the 4-point harness and
leg restraints.
1. The patient should be secured using the harness and both
leg restraints.
2. Dispose of and replace any restraints that are worn,
damaged or have been involved in any accident – they may
have hidden damage.
3. Unbuckle all restraints and lay the straps out of the way
before transferring the patient.
4. Transfer the patient onto the trolley using recognised
techniques.
5. To secure the 4 point harness, slide the two buckles on the
shoulder straps onto the buckle on the right hand side strap
and then clip left hand side to the right hand side buckle.
Adjust the shoulder straps so they are snug against the
patient’s shoulders and adjust left and right hand side straps
so they are snug against the patients sides.
6. Fasten the two leg restraints and adjust to ensure patient
comfort.
7. To release the harness, press release button.
The battery charge status can be determind by pressing the
indicator button on the battery and LED's will light as per
table below.
Figure 3 - Battery LED chrage status
