67
INSTALLING TABLE ASSEMBLY
1. Locate table support and (3) hex head screws, M6 x 1,0-14,
washer and lockwashers among loose parts.
2. Position table support against table, aligning holes as shown.
3. Fasten table support to table as shown.
WARNING: To avoid trapping the work or fingers
between the table and sanding surface, the tableedge
should be a maximum of 1/16 inch from sanding surface.
7. Loosen the (3) hex head screws and adjust table.
HEX SCREW
LOCK
WASHER
WORK SUPPORT
HEX SCREW
FLAT
WASHER
WRENCH
WORK SUPPORT
GALDS
SKR
Ū
VE AR SEŠST
Ū
RU
GALVI
Ņ
U (3)/
GALDA BALSTS
APTURES PAPL
Ā
KSNE (3)
PAPL
Ā
KSNE (3)
TABLE
SUPPORT
BASE
INDEX
PIN
WASHER
TABLE LOCK
KNOB
4. Locate washer 6,5 x 17.8 x 1,6 and knob among loose parts.
5. Position table support in corresponding holes on side of base
as shown. Make sure the 9,5mm diameter index pin aligns with
upper hole.
6. Place washer on threaded shaft of knob and insert through slot
into threaded holes of base.
1/16 INCH MAXIMUM
SANDING SURFACE
TABLE
TABLE LOCK KNOB
OWNERS MANUAL
WORK TABLE
10 PAGES
SCALE LABEL
8. Use your Owner`s Manual as a spacer. Place ten pages of the
Owner`s Manual between the Dise and the front edge of the ta-
ble. Hold the table against the manual and tighten the three (3)
Hex Washer Head screws.
AUXILIARY MOUNTING FOR VERTICAL
SANDING
1. Remove backstop lock bolt and remove work support.
2. Remove table assembly by removing table lock knob and
washer.
NOTE:
Belt bed may be raised to vertical position by loosening
hex socket screw and raising bed. See “Positioning Belt Bed” on
page 16.
3. Attach table assembly to auxiliary holes in belt bed. Make
sure index pin is in the upper hole when sanding table is in the
vertical position.
