Fenix RC10 User Manual Download Page 1

Max 380 Lumens

FENIXLIGHT LIMITED

Tel:+86-755-29631163/83/93    Fax:+86-755-29631181

http:www.fenixlight.com

E-mail:[email protected]

Address: 8/F,2nd Building,DongFangMing 

Industrial Center,33rd District,Bao'an,

Shenzhen 518133,China

Fenix performance travels far and wide with the high-intensity, 

rechargeable RC10. Quick to regain power and fast switching 

with on-body controls, this convenient light peaks at 380 

lumens. Durable and equipped for in-vehicle and home 

charging, RC10 is well suited for professional, recreational 

and personal use.

 Uses Cree XP-G (R5) LED with a lifespan of 50000 hours

 Built-in 2200mAh/3.6V rechargeable Li-ion battery

 The charging equipment supports AC charger and car 

    charger

 161mm (Length) x 25.4mm (Diameter) x 34mm(Head)

 200-gram weight (excluding the battery)

 Digitally regulated output maintains constant brightness

 Anti-roll, slip-resistant body design

 Tail side mode switch button for fast mode selection and 

    instant strobe function

 Made of durable aircraft-grade aluminum

 Premium Type III hard-anodized anti-abrasive finish

 Toughened ultra-clear glass lens with anti-reflective coating

Notice: The above-mentioned parameters are approximate 

and may vary due to different environments.

 

Operation Instruction

Button for one second to temporarily enter into Strobe 

mode. It will return to the general mode unless pressed.

With the flashlight on, a single press of the side mode 

switch button allows switching between Turbo

Low

Mid

High

brightness levels. Press and hold the mode 

switch button for one second to enter into Strobe mode. 

Press and hold the mode switch button again to return to 

the general mode.

RC10 memorizes the brightness level while in the general 

mode. When turned off and then on, the flashlight 

automatically enters into the general mode.

Battery charging

The RC10 has a low-voltage warning function. When 

voltage is checked, the flashlight enters the lower 

brightness level; if low voltage is checked in the Low 

brightness level, it will blink three times per second every 

five minutes. In this case, the battery should be charged or 

it will cause damage to the battery.  To ensure normal use, 

the flashlight will not turn off automatically until the battery 

protection function begins to work.

The built-in battery has the over-discharge protection 

function. When the voltage is extremely low, RC10 will turn 

off automatically to protect the battery from over discharge. 

The function will not influence the normal use.

 When the charger is plugged into a household outlet, the 

indicator light will turn green. Put the flashlight into the 

charger and rotate it until it clicks into position. 

We will replace products afflicted with manufacturing defects 

within 15 days of purchase and repair a light free of charge 

within 24 months of purchase if problems develop with normal 

use; if repair is required after 24 months from the date of 

purchase, we will charge for parts. The total repair fee is 

dictated by the cost of the replaced materials.

Fenix flashlight accessories (including the batteries) can enjoy 

one-year free warranty period in the condition of normal use 

since the purchase date.

Product Warranty

Warning

RC10 is a high-intensity lighting device and capable of 
causing eye damage to the user or others so please avoid 
shining the light directly into anyone

s eyes.

Warranty Card Registration

We kindly suggest that you register your guarantee card on the 

official website of Fenixlight Limited. You can get an extra six-

month warranty period once you have successfully registered. 

What's more, you could take part in the lottery of questionnaire 

at the same time.

Fenix RC10 Flashlight 

Technical Parameters

 Please don't disassemble the sealed head as doing so 

can cause damage to the flashlight and will void the 

warranty. 

 Due to the momentary-on tactical switch, the flashlight 

can be activated when stored, transported or placed in a 

pocket.  Unscrew the tail cap one-half turn or take out the 

battery to avoid unwanted operation.

 Long-term use can result in O-ring wear.  To maintain a 

proper water seal, replace the ring with an approved spare.

 Periodic cleaning of the battery contacts improves the 

flashlight

s performance as dirty contacts may cause the 

RC10 to flicker, shine intermittently or even fail to 

illuminate for the following reasons:

Reason A: 

The battery lacks power.

Solution:

 Charge the battery.

Reason B:

 The threads, PCB board contact or other 

contacts are dirty.

Solution:

 Clean the contact points with a cotton swab 

soaked in rubbing alcohol.

If the above methods don't work, please refer to the 

w a r r a n t y   p o l i c y   b e f o r e  c o n t a c t i n g   y o u r   a u t h o r i z e d 

distributor.

Notice: The routine cleaning video can be watched and 

downloaded through the Fenix website by clicking on the 

RC series followed by the maintenance tab.

Usage and Maintenance

380 LUMENS

40 LUMENS

140 LUMENS

General Mode

Low 

Mid 

High 

Turbo 

215m

11592cd

IPX-8, underwater 2m

1m

AC charger, car charger, battery charger, lanyard and spare o-ring
 

6h 10min

5 LUMENS

 142h 

Strobe  

380 LUMENS

26h 30min

1h 55min

Turning RC10 on/off

Press the tail cap switch lightly to momentarily activate the 

flashlight (unless pressed, it will remain off). Press the tail 

cap switch completely to turn on the flashlight and lock it. 

Another press will turn it off.

Mode selection

With the flashlight off, press and hold the mode switch

The indicator light will now switch to red to indicate 

charging has begun. When the indicator light returns to 

green, the charging cycle has been completed. The 

charging time will be about 3 hours.

When the flashlight is on, please do not charge the battery. 

Or it will extend the charging time or it can not charge fully. 

If it is needed urgently, it will still be ok to charge the 

battery with the flashlight on. However due to the output 

protection function, RC10 can not enter into the Turbo in 

this case.

Note: The battery will discharge automatically, please 

charge the flashlight every four months to maintain the 

maximum performance of the battery when RC10 is not 

used for a long time.

Available Accessories

Type

Model

Transparent diffuser tip

AD102

Camping lamp shade

AD502

Traffic wand

AD202

Bike mount

AF02

Gun mount

ALG-01

Filter adapter

Ad302

Note:  For full details about 

available accessories, please 

visit the Fenix website, click 

on Products followed by 

c l i c k i n g   t h r o u g h   t o   t h e  

accessories page.

Side mode switch button

Head

Reviews: