TS1700/TK18 PRINTERS OPERATION MANUAL
FS
p
n
m
[Name]
Print NV bit image
[Format]
ASCII
FS
p
n
m
Hex
1C
70
n
m
Decimal
28
112
n
m
[Range]
<01>H
≤
n
≤
number of saved logo; <30>H
≤
m
≤
<33>H
[Description]
Prints a NV bit image
n
using the mode specified by
m
.
m
Mode
Vertical
Dot Density
Horizontal
Dot Density
<30>H
Normal
203.2 dpi
203.2 dpi
<31>H
Double-width
203.2 dpi
101.6 dpi
<32>H
Double-height
101.6 dpi
203.2 dpi
<33>H
Quadruple
101.6 dpi
101.6 dpi
[dpi: dots per 25.4 mm]
n
is the number of the NV bit image (always 1).
m
specifies the bit image mode.
[Notes]
●
NV bit image means a bit image which is defined in a non-volatile memory by
FS q
and printed by
FS p
.
●
This command is not effective when the specified NV bit image has not been defined.
●
This command is effective only when there is no data in the print buffer.
●
This command is not affected by print modes (emphasized, double-strike, underline,
character size, white/black reverse printing, etc.).
●
If the printing area width set by
GS L
for the NV bit image is less than one vertical
line, the following processing is performed only on the line in question. However, in
NV bit image mode, one vertical line means 1 dot in normal mode (
m
=30H) and in
double-height mode (
m
=31H), and it means 2 dots in double-width mode (
m
=32H)
and in quadruple mode (
m
=33H).
●
If the printing area width cannot be extended by one line vertically, the left margin is
reduced to accommodate one line vertically.
●
The printing area width is extended to the right in NV bit image mode up to one line
vertically. In this case, printing does not exceed the printable area.
●
If the downloaded bit-image to be printed exceeds one line, the excess data is not
printed.
●
After printing the bit image, this command sets the print position to the beginning of
the line and processes the data that follows as normal data.
[Reference]
FS q, GS v 0
51/62
