Fema Electronica S40-P, User Manual

Page: 11 / 20

FEMA ELECTRÓNICA . Series S . S40-P
11
1.10 Configuration menu (cont.)
Tools
Option 1
Configuration menu for the module installed at Opt.1
Option 2
Configuration menu for the module installed at Opt.2
Password
Version
Factory reset
Minimum
Brightness
Maximum
Standard
Excitation Volt.
5 Vdc
10 Vdc
15 Vdc
20 Vdc
Disabled
1.10.11 Excitation voltage
The ‘ Version ’ (‘ VEr ’) menu informs of the current firmware version
installed in the module.
At the ‘ Password ’ (‘ PASS ’) menu select a 4 digit code to block access
to the ‘
configuration menu
’. Instrument configuration will not be ac -
cessible to non authorized personnel. To activate the ‘ Password ’ se-
lect ‘ on ’ and introduce the code.
The code will be requested when trying to access the ‘ configuration
menu ’ (key ‘SQ’ (
<
)). The ‘ fast access ’ menu is not password pro -
tected.
1.10.12 Function ‘Password’
At the ‘ Brightness ’ (‘ LIGh ’) menu select the light intensity for the
front leds. With this function it is possible to adapt the instrument to
the environment light intensity.
1.10.13 Factory reset
At the ‘ Excitation Volt ’ (‘ V.EXc ’) menu select the excitation voltage
value at 5 Vdc, 10 Vdc, 15
Vdc or 20 Vdc. Select ‘
oFF ’ to disable the
excitation voltage.
1.10.14 Firmware version
Menus ‘ OPt.1 ’ and ‘ OPt.2 ’ give access to the ‘
configuration menus’
of the output and control modules installed at slots Opt.1 and Opt.2.
See section
2
for a list of output and control modules available for
each slot. The ‘
configuration menu
’ of each module is described at
the User’s Manual of each module.
1.10.15 Brightness
At the ‘
Factory reset
’ (‘
FAct
’) menu, select ‘
yes
’ to load the default
factory configuration for the instrument
(see section 1.15).
1.10.16 Access to optional modules