INSTALLATION GUIDE
REFLEX FUSION PLUS® SHOWER MIXER 195MM
RFSPCSMCL
SYSTEM REQUIREMENTS
Operating Pressures - refer to the Venturi Selection Table on page 2
Unequal Pressure - Venturi jet installed
Operating Pressures
Equal High (Mains) & Equal Low Pressures - Venturi jet removed
Operating Hot Water Temperatures
Operating Cold Water Temperatures
Do not plug outlet when testing.
This shower mixer can be line tested up 1500kPa (217.6psi)
WHAT IS IN THE PACK
MINIMUM
MAXIMUM
36kPa (5.1psi)
36kPa (5.1psi)
200kPa (29.0psi)
1500kPa (217.6psi)
1500kPa (217.6psi)
55° C
60° C
5° C
N/A
Hot
Cold
Mixer Assembly
2.5mm Allen Key
8g x 32 Dome Head
Square Drive
Stainless Steel Screws
Grub Screw
Handle Cap
AS/NZS 3500.1 states that pressures above 500kPa can cause damage from water hammer, reduce the life of
appliances, taps & fittings, cause excessive noise in the system and recommend that a pressure limiting valve (PLV) be fitted.
2x Venturi Jets for Unequal Pressures
Round Top
Hex Top
Red
O-ring
Black
O-ring
TOP VIEW
TOP VIEW
BEFORE INSTALLATION
MIXER ORIENTATION
Pipework MUST be purged before connecting to the mixer
This mixer is designed to be connected with the hot water
supply on the left only and the cold water supply on the
right only.
If at any point the nut is removed, please ensure that both
black lines marked on the cartridge and cartridge nut are
aligned when the mixer is in full cold position as shown in
figure 1.
HOT
INLET
ONLY
COLD
INLET
ONLY
( FULL COLD POSITION )
Figure 1.
OUTLET
Page 1
Handle
Fac O-Ring
Patented New Zealand No. 605175
IMPORTANT:
Factory fitted
WITHOUT
Venturi Jet
