Page 6
KataEX-FM
Assembly
Step #6: install lockout set screw(s), if desired
Default rotation of the fixed arm and motion arm is 360°. Installation of a lockout set screw limits rotation to 180°.
• To lockout rotation of the fixed arm, install one of the M4x15 set screws in the underside of the arm stem. Tighten the screw, then back it off one turn.
— Installing a set screw in the front hole allows 180° rotation to the right only. A set screw in the rear hole allows 180° rotation to the left only.
• The fixed arm or motion arm must be in its allowed range of rotation when installing the lockout set screw.
Step #7: organize cables and cords
• Capture the cables and cords with the cable covers. Slide the cable covers as shown to attach them to the monitor arms.
• Snap the cable clips onto the post and into the recessed groove above the base.
• Route the monitor cables and power cords toward the rear by slipping the cords into the opening on the cable clips.
180°
front screw
rear screw
180°
front screw
rear screw
set screw
M4x15
2mm
Allen key
front
rear
capture
cables
with clips
snap on
cable clips
install covers over cables
slide in
slide in
slide
down
