Page 4
Kata
™
slider mount
retrofit procedure
step 3: assemble slider mount
IMPORTANT:
When assembling the slider mount, the groove on the slider bar must be at the bottom.
• Slide the VESA mount assembly onto the slider bar. Center the assembly on the slider bar.
• Install the M4x15 locking screw into the bottom of the VESA mount assembly. Using the 2mm Allen key,
tighten the locking screw to hold the assembly in place. Be sure the screw fits into the groove.
— After the monitor has been installed, the VESA mount can be moved anywhere along the slider bar
by loosening the locking screw no more than one full turn, so that it stays inside the groove. Be sure
to re-tighten the screw to secure the monitor in the desired position.
step 4: position slider mount on monitor arm
• First, position the bushings.
— Place the upper bushing on the top opening of the slider mount.
— Place the lower bushing onto the bottom opening of the monitor arm.
• Position the slider mount onto the monitor arm. Be sure the
bushings remain in place.
screw cover
lower bushing
upper
bushing
socket cap
screw
4mm
Allen key
slider bar
VESA mount
assembly
2mm
Allen key
slider mount set screw
M4x9
groove
