Page 17
Step #12: organize cables and cords
The illustration below shows a fixed+motion three monitor arm configuration. All possible cable covers are shown: motion arm, fixed arm, and arm stem.
• Capture the cables and cords with the cable covers. Slide the cable covers as shown to attach them to the monitor arms and arm stems.
• Snap the cable clips onto the post and into the recessed groove above the base.
— With two rows of monitors, snap a second cable clip onto the post under the top row.
• Route the monitor cables and power cords toward the rear by slipping the cords into the openings on the cable clips.
KataEX
Assembly
capture
cables
with covers
install covers
over cables
slide in
slide in
slide
down
capture
cables
with clips
snap on
cable clips
