Page 8
Under-desk mount
With this method, the top bracket is turned
upside-down so that it can be mounted to the
underside of the worksurface with M4x14 wood
screws. As with the other methods, the power
module is mounted to the bracket using two
M3x12 panhead screws.
Step #1: remove top bracket
• Unscrew the M5x8 socket cap screws using the M4 Allen key.
• Remove the top bracket from the bracket/clamp assembly.
#6-32x¼
top
bracket
top
bracket
Step #2: mark and drill pilot holes
• Use the top bracket as a template to mark where to drill
four pilot holes.
— Position the bracket at the desired location, typically at
the front of the worksurface on the left or right side.
— Mark hole locations.
• Drill ½" deep pilot holes using a
1
/
8
" drill bit.
Caution: Be careful not to not drill through the top of the
worksurface.
FlexCharge4CX Under-desk mount
