Page 4
Edge Mount
With edge mounts, the product is clamped to the
edge of the worksurface.
Step #1: if necessary, raise clamp on bottom bracket
Skip this step if worksurface thickness is 0.9" or more.
• The clamp is attached to the lower two holes on bottom bracket. If worksurface thickness is less than
0.9", clamp attachment must be moved to the upper two holes.
• Use the M4 Allen key to unscrew the two
M5x8 socket cap screws that secure the
clamp.
• Raise the clamp to the upper two holes
and attach it using the socket cap screws.
Tighten securely using the Allen key.
Step #2: attach bracket/clamp assembly to power module
• Route the power cord through the opening in the
top bracket.
• Attach the top bracket to the rear of the power
module using the two M3x12 panhead screws.
Hand-tighten securely.
power module
clamp
bottom
bracket
top
bracket
M3x12
clamp
bottom
bracket
M5x8
socket cap
screw
FlexCharge4CX Edge mount
