FELIX
Pro Series
Page
1
4
Calibration guide
This guide is made to help you setup and maintain a
perfectly calibrated printer for the best end result. It
will go over how to set up the correct offset of the bed,
calibrating the Z height of the extruders so the both
match each other and setting the X and Y offset
correctly for perfect dual color or dual material prints.
5
Bed leveling and first layers
Intro
All the Pro series come with automatic bed leveling
and this usually works right out of the box, but when
changing hot ends or after sometime, fine tuning
might be required to get that perfect first layer again.
The first layer is the most important layer of the whole
print if this layer is too close or too far you’ll see the
effects throughout the whole print.
