12
Planer-Thicknesser
A 941 / AD 941 / AD 951
2.11 Foreseeable misuse
Note:
The examples given are for the purpose of bringing your attention to some of the dangers that could occur,
they are not however comprehensive and cannot be used as a legal foundation.
Nevertheless, this information is provided to help the operator better assess hazards and risks.
Safety
General safety rules:
•
Failure to follow the operation manual..
• Operating the machine, even if the operation manual is incomplete or not in the language of the country it is in.
•
Placing of material or tools on the work surface.
Components and tools that are not put in their correct place or put away may be the cause of accidents!
• Usage of a tool system that is not suited for the material or the machine.
Only clamp authorised tools to the machine.
• Usage of a modified module and tool system.
Only use original manufacturer tools
• Fitting of spare parts and usage of tools and accessories that are not permitted by the manufacturer.
Use only genuine spare parts supplied by the manufacturer.
• Making changes and modifications to the machine
• Bridging or adaptation of protective equipment.
During operation:
•
Processing of workpieces that are too large or too heavy.
•
Processing of very small workpieces without assistance.
Keep handling auxiliaries at hand: See chapter entitled >Operation<
•
Processing of unsuitable materials such as metal.
•
Processing of workpieces that are not, or insufficiently held in place.
•
Processing of workpieces in the same direction as the rotation of the tool.
(Feed direction corresponds to the rotational direction of the tool.)
• Using the machine without the appropriate safety equipment.
Ensure that all safety devices have been installed properly.
• Deliberately bad or irresponsible behaviour on the machine whilst operating.
Every time the machine is being serviced:
• Service work carried out by untrained or unauthorised personnel.
• Non-compliance with maintenance guidelines.
See chapter entitled >Service - Maintenance schedule<
• Failure to observe signs of wear and damage.
Summary of Contents for AD 941
