Gimbal Connection Diagram
Adapter
(Down)
Mode Switch
( Only use in 3-axis gimbal )
Ⅰ
Ⅱ
Ⅲ
Install the damping ball to the adapter (Up),
then install the adapter (Up) to the aircraft.
V hanger is optional part to use if necessary.
MiNi 2D 2-Axis Brushless Gimbal For Aircraft
Suitable For Gopro4 / / Gopro3 or the cameras with the similar size
Install the camera
Manual Version 3.0
END
Install the damping ball to the Adapter(Down)
RC Receiver
+
-
-
-
Power Connection
Black
Black
Black
Black
Red
Red
Yellow
White
Blue
Pitch Control
Roll Control
Video Output
Brown
GoPro camera must be installed
before supplying power to the
Gimbal. Failure to do so will result
in damage to the gimbal motors.
MiNi 2D 2-Axis Brushless Gimbal ( For aircraft ) suitable for GoPro4, / 3 or cameras with similar size.
Can be easily mounted in fixed wing, multirotor, helicopter for aerial photography, and can work
independently only need power supply.
You can assemble the gimbal properly according to the drawing, and then install the video camera on it.
There is no need to set up and adjust the parameter. For the first use, power on the Gimbal, and then
keep it static for a while, after its reset, the gimbal will be in a level position automatically. Then you can use
it normally.
Introduction
1
WARNING !
WARNING !
!
Make sure that the connection to
the computer is done by the
USB Connector
1.
2.
2
Install Step
Screw
Hexagonal Socket Head Cap Screw
Adapter
( Up )
Adapter
( Down )
V Hanger
Damping Ball
(
Not Included）
M2.5×5mm
1
2
3
4
5
V Hanger
3
Install Mode
This interface can be output 5
voltage and input analog video
signal of GoPro camera
Video Output And
Camera Charging
Cable
5V
Video
Control
Video
GND
Note: RC receiver needs to be
powered separately
1
3
5
1
2
3
4
M2×25mm
Knurled Thumb Screw
Vertical Installation Diagram
Inverted Installation Diagram
Install "V" Hanger
Default
