Assembly
4
WWW.FEIT.COM
Please contact 1-866-326-BULB (2852) for further assistance.
Take out the LED Work Light Body (AA),
the H-Stand (BB), the Locking Knob (CC),
the Locking Washer (DD) and the Washer (EE).
1
3
2
Fig. 1
AA
AA
CC
BB
BB
CC
DD
EE
DD
EE
Locking Knob
Horizontal Pivoting
Once the LED Work Light Body (AA) has been attached to the Stand (BB), the LED Work Light can pivot vertically and horizontally into the
desired position.
To pivot horizontally loosen the center Locking Knob then adjust
to your preferred position. Once set to your desired position,
re-tighten the center Locking Knob to lock it into place.
Vertical Pivoting
To pivot vertically, simply adjust the Work Light to your
preferred position. Once set to your desired position,
additional tightening can be done using the Hex Key Allen
Wrench (FF) found on the sides of the work light.
Attach the LED Work light Body (AA) to the H-Stand (BB) by first
inserting the Locking Washer (DD) and Washer (EE) onto the
Locking Knob (CC) and screwing the Locking Knob (CC) through
(AA) and into the stand (BB) (see Fig.1). Tighten Locking Knob
(CC) to set into place.
