Fein 7 238 12, Operating Instructions Manual

Page: 11 / 83

MF 12-180
11
EN
Setting the stop (3).
Risk of injury
by switching the tool ON unintentionally.
Before adjusting, pull out the mains plug.
■
For setting the cutting depth, unscrew
the wing bolt, set the desired cutting
depth and tighten the wing bolt again.
Changing the diamond disc (8).
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
■
Pull the sole-plate for fixing the suction
cage (7) a few millimeters towards the
power tool.
■
Pull the cover plate of the extractor
cage towards the back.
■
Let go of the sole-plate and completely
remove the cover plate.
■
Press the locking button (5) and keep it
pressed, if necessary turning the dia-
mond disc (6) slightly until it locks.
■
Unscrew the 4 fixation screws (8) and
remove.
■
Change the diamond disc (6).
■
Tighten the 4 fixation screws (8),
tightening torque 1.8–2.0 Nm.
■
Push the cover plate onto the extractor
cage until the sole-plate (7) firmly locks
it.
Cleaning and care.
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
■
Clean the venting openings.
■
Blow out the motor space from outside
with dry compressed air.
Maintenance and repairs.
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ised service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), reference no. (2) as well
as the number of spare parts (3) facilitates
the ordering procedure.
!
!
!
!
3 41 01 041 06 0 - Buch Seite 11 Mittwoch, 3. September 2003 3:36 15