TST
Assembly instructions
FUZ2 -A/-B/-C/-CX/-L
FEIG ELECTRONIC GmbH
Page 40 of 71
FUZ2-A-B-C-CX-L_Montageanleitung_GB_10.docx
7.2 Editing a selected parameter
7.3 Exit parameter operation mode
Keep the STOP button pressed for approx. 3 seconds in
order to leave the parameter mode and change to the
door mode. The door operation is active when the
display shows for example:
FEIG ELECTRONIC
xxxx Cycles
_
Eu_
7.4 Execute a reset
+ +
press simultaneously for approx. 3. hold for seconds.
7.5 Entry into the extended parameter configuration mode
In order to reach the extended parametrization mode, a
password must be entered in advance. The following
parameter must be set for this:
P: Password |
999= 0001 #
P
.
999
P.999 = 2 (extended commissioning mode)
P: Password |
999= 0001
#
0001
P: Password |
999= 0002?#
0
0
0
2
P: Password |
999= 0002
#
P
.
999
1.
By briefly pressing the
STOP key on the membrane
keypad, the cursor moves to the right to the stored value
(the parameter is opened) or the preset value is displayed.
P: Offenhalt1 |
010= 10 s
P.
010
P: Offenhalt1 |
010= 10
s
10
2.
The parameter value is increased with the OPEN button
and reduced with the CLOSE button.
If the value has not yet been saved, a question
mark is displayed after the number or the decimal
point flashes.
P: Offenhalt1 |
010= 9?s
9
3.
If the
STOP key is only pressed briefly, the set value is
not saved and the value is changed to the originally stored
value, i.e. the original value is displayed.
P: Offenhalt1 |
010= 10
s
10
If you keep the
STOP key pressed until the check mark
is displayed or the decimal point no longer flashes,
the changed value is saved.
P: Offenhalt1 |
010= 9
s
9
4.
If you now press the
STOP key briefly, you change to
the display of the parameter name or the cursor jumps back
to the parametrization.
P: Offenhalt1 |
010= 9 s
P.
010