Feig Electronic OBID i-scan ID ISC PRHD102, Manual

Page: 119 / 125

OBID i-scan
®
Manual ID ISC.PRHD102
FEIG ELECTRONIC GmbH Page 119 of 125 H71101-2e-ID-B.doc
ANNEX D: Index of Status Bytes
Hex-value General
0x00
OK:
•
Data / parameters have been read or stored without error
•
Control command has been executed
Hex-value
Transponder Status
0x01 No Transponder:
•
No Transponder is located within the detection range of the Reader.
•
The Transponder in the detection range has been switched to mute.
•
The communication between Reader and Transponder has been interfered and the Reader
is not able to read the Transponder anymore.
0x02 Data False:
•
CRC16 data error at received data.
0x03
Write-Error:
Negative
plausibility
check of the written data:
•
Attempt to write on a read-only storing-area.
•
Too much distance between Transponder and Reader antenna.
•
Attempt to write in a noise area.
0x04 Address-Error:
The required data are outside of the logical or physical Transponder-address area:
•
The address is beyond the max. address space of the Transponder.
•
The address is beyond the configured address space of the Transponder.
0x05 Wrong Transponder-type:
This command is not applicable at the Transponder:
•
A special command is not applicable to the Transponder.
0X08 Authent Error
•
If access password is wrong
Hex-value Parameter Status
0x10 EEPROM-failure:
•
The EEPROM of the Reader is not able to be written on.
•
Before writing onto the EEPROM a faulty checksum of parameters has been detected.
0x11 Parameter-Range-Error:
•
The value range of the parameters was exceeded.
0x13 Login-Request:
•
Configuration access without having logged in to the Reader before.
0x14
Login-Error:
•
Login attempt with wrong password.
0x15 Read Protect:
•
The configuration block is reserved for future use.
0x16 Write Protect:
•
The configuration block is reserved for future use.