IDENTIFICATION
ID PAD74-U
INSTALLATION
Page 6 of 15
1.2 Available Software-Tools, USB drivers and Firmware
The service software and the corresponding USB driver (HF/UHF reader or FEIG ID driver) for personal
computers with Microsoft® Windows® operating systems, are available on the Feig homepage
under "Service -> Driver".
Further documents and software tools can be found under the link:
Login: CPR74
Password : FE900
NOTE:
•
The Reader ID PAD74-U reports itself in I 2023 (version 11.08.xx or higher) as "ID CPR74".
•
A firmware update tool and an xml firmware file are available for firmware updates.
1.3 Difference between ID PAD74-U and ID CPR74-CUSB
The reader module installed in the ID PAD74-U does not support all commands and functions that are available in the
reader module ID CPR74-CUSB.
(see Manual H60410-Xe-ID-B)
Since ISO 15693 and ISO 14443-A/B transponders are mainly used in the intended applications, the following
transponder drivers have been switched off in the reader configuration and cannot be activated.
Unavailable functions and transponder drivers:
•
ISO 18000-3M3
NOTE:
•
The ID PAD74-U rejects the activation of an invalid transponder driver" with the error message
"Parameter Range Error".
•
The commands of the internal reader ID CPR74-CUSB belonging to the disabled transponder driver are not
available.
•
In the factory default state, the provided antenna (ANT2) inside ID PAD74-U is activated.
The internal antenna installed on the reader module ID CPR74-CUSB can additionally be activated via the reader
configuration.
