IDENTIFICATION
ID HyWEAR compact
5 Product Description
Page 14 of 41
5.3 Approvals
5.3.1 Europe (CE)
This equipment is intended to be commercialized in all the countries of the European Union and there is no
commercialization or operational restrictions in any of the countries.
Hereby, FEIG ELECTRONIC GmbH declares that this Bluetooth, Wi-Fi barcode scanner is in compliance
with the essential requirements and other relevant provisions of Directive 1999/5/EC.
Performance Classification according to ETSI EN 301 489: Class 2
5.3.2 USA (FCC)
Product name:
ID HyWEAR compact
FCC ID:
PJMHYWCMPCT
Notice for USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions.
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Unauthorized modifications may void the authority granted under Federal communications
Commission Rules permitting the operation of this device.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
This equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment. The equipment must not be co-located or operating in conjunction with any other
antenna or transmitter.
The wireless device should be used in accordance with the instructions in the User Guide.
NOTE:
Changes or modifications made to this equipment not expressly approved by
FEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.
