14
OPERATION
WARNING! The product must be fully assembled before operation! Do not use a product that is only
partly assembled or assembled with damaged parts!
Notes
1.
Check the cutting
disc
before every use for damage and wear. Replace it with a new one if required.
2.
Only use a cutting
disc
that is suitable for the intended application.
3.
Do not use any abrasive wheels.
4.
The operator should stands on the right side of the machine ( near the ruler side), facing the direction o
f the guide rail, then holds the handle with right hand,pulls the machine head to cut.
a.
Remove the fixation bolt(41) before use.
b.
Before switching the machine on, make sure that the water pump is immersed.
c.
Switch on the machine before the cutting disc touches the workpiece.
d.
Place the workpiece against the fence or mitre fence.
e.
Keep the workpiece in place and slowly guide the cutting disc through the workpiece.
f.
Do not exert pressure on the cutting disc. Allow the machine enough time to cut the workpiece.
g.
Regularly check if the cutting disc is sufficiently cooled.
h.
Make sure that the lower edge of the cutting disc is well below the water level in the cooling water tray.
Add some cooling water if necessary.
i.
Lock the head after use.
Switching on and off
- To switch the machine on, set the on/off switch (1) to ‘I’.
- To switch the machine off, set the on/off switch (1) to ‘0’
MAINTENANCE
CLEANING
Empty the water reservoir and remove from the reservoir and the table any dust deposits remaining after
cutting. Clean the tile cutter using clean, dry cloth. From time to time, depending on the degree of dust
deposit accumulation, clean the water pump, making sure that filters are clean and not clogged.
REPAIR
This product does not contain any parts that could be repaired by the customer. For service and repairs
turn to a qualified professional at SWAP, https://swap-europe.com
Power supply
If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his agent in
order to avoid a safety hazard.
TRANSPORTATION
a)
Before transporting and moving the product to any other location, turn it off and unplug the power.
b)
Install transport covers, if applicable.
c)
Protect the product from strong impacts or strong vibrations that can occur during vehicle transport.
d)
Protect the product from slipping and falling over.
