13
- Loosen the bevel locking knobs on both sides (11).
- Set the required angle using the pointer (10).
- Tighten the locking knobs.
MOUNTING AND ADJUSTING THE MITRE FENCE (FIG. F)
The mitre angle is infinitely variable between 0° and 45°.
To install the mitre fence proceed as follow :
- Loosen the screw (38) a few turns.
- Insert the sliding block (39) into the long fence (17).
- Set the mitre angle or adjust the mitre fence for use as an end stop.
- Tighten the screw (38).
To set the mitre angle, proceed as follows:
- Loosen the lock knob (35).
- Set the desired angle using the finger on the protractor (33).
- Tighten the lock knob (35).
FITTING THE PUMP (FIG. G)
- Make sure that the water pipe (25) is fully connected to water pump (13).
- Lower the pump (13) carefully in the water.
- Check if the motor can be freely moved back and forth. The mains cable and hose should not be pulled
tight and the pump should not be pulled out of the water.
Never let the pump run dry. Always make sure that the suction opening is fully immersed.
MOVING THE CUTTING HEAD (FIG. H)
Remove the fixation bolt (41) to allow the cutting head to be moved.
During transport and storage the head should always be fixed thanks to bolt (41)
FILLING THE WATER TRAY :
Before filling the water tray always turn off and unplug the tool!
WARNING! Lack of cooling water may damage the saw disc .Never turn on the machine without enough
water in the tray or without plugging in the water pump!
a)
Insert the water plug into the hole of the water tray.
b)
Pour water into the tray. To ensure proper operation, make sure the pump is always full immersed in
the water( about 2/3 depth of water tray). Do not overfill. Check the water level constantly during use and
refill if necessary.
CAUTION! If the water flow from the pump is reduced or has stopped. Change for
a new pump or have
the pump repaired by qualified personnel.
NOTE:
To drain the water, remove the water plug from the hole in the water tray and allow it to drain, or
remove the water tray and pour the water out!
