15
3.3.4 PTZ
L2 PLUS can control cameras which supports VISCA protocol. L2 PLUS allows users to control
camera to move, zoom and focus. Meanwhile, it also saves camera position and zoom information
for quick retrieval the next time you use it. (L2 PLUS can control up to 8 cameras)
3.3.5 LOGO Overlay
3.3.6 Chroma Key
1. Enable the Chroma key
2. Select the base color you want to remove, there are 6
kinds of colors you can select: orange, yellow, green, cyan,
blue and purple.
Adjust color in the range of MAX, MIN and MARGIN.
Note:
When operating the camera, L2 PLUS needs to remain in the Control interface, otherwise the PTZ
camera cannot be controlled.
Enable the LOGO overlay and adjust the position
(If it is the first time to set LOGO, please refer to <5.2.17
LOGO>and import the picture in the software.
1. Enable the PTZ camera and set the IP of the camera you
want to control to the corresponding IP address. (the IP
address of camera should be in the same network
segment with that of L2 PLUS)
2. you can control PTZ camera’s position, zoom and focus
as shown in the right picture.