9
Configuring the Light
Installation and Service Instructions
Federal Signal
www.fedsig.com
USE THE DIMMING/LOW POWER FUNCTION PROPERLY: Enabling the
Low Power function in the light bar may cause the light output to fall below
certain light output standards and guidelines for emergency warning lights.
Use extreme caution when using this function. Ensure that the ambient
light conditions are low enough that you are seen and that the reduction of
glare from the light bar is safer than full light output in the situation. Failure
to heed this warning may result in serious injury or death to you or others
in your vicinity.
Table 4 Flash patterns
1
Triple 92.3
14 Double 120*
2
Triple 90
15 Triple 80*
3
Single 122
16 Triple 120*
4
Single 75*
17 Quad 60*
5
Single 90*
18 Quad 75*
6
Single 113*
19 Quad 95*
7
Cruise w/ Flicker
20 FedPulse Quad 75*
8
Random Time
21 Quint 75*
9
Random Common*
22 7X
10
Steady
23 Single Quad*
11
Single 75*
24 Decelerating
12
Single 120*
25 Accelerating
13
Double 80*
*Conforms to California Title 13
Table 5 S2 Flashing Modes
Seconds COLOR 2 LED Response Action
0–1
Bright
Next COLOR Mode
1–3
Dim
Previous COLOR mode
3–5
Low
Toggle Sync Simultaneous, Alternate
5–7
Bright
Toggle Pattern All, Split
**
7–9
Dim
Swap Colors (COLOR Modes 5, 6, 7, 8, 9, and 10)
9+
Low
Reset Switch 2 settings to default
**Pattern 17 (Steady Half 75) is split by default. No split option for
FedPulse 75 and Cruise patterns