54
Web Browser Activation
Series C
Federal Signal www.fedsig.com
Web Browser Activation
The following section describes how to activate from a built-in web server that allows the
to be controlled and configured over a LAN using standard web browsers.
The must be configured with the S software to enable Ethernet
communications and configure IP settings before the can be used on a LAN.
The System Administrator identifies the server IP address, Subnet Mask, Default Gateway,
and the IP addresses for all devices.
If the configuration details are lost or changed incorrectly and it becomes necessary
to restore the to factory default settings, see the Restoring Configuration to
Factory Defaults section.
Logging In the Web Interface
To configure the network interface through the web browser:
1. Prior to installing devices on an IP network, use the S software to
activate the Ethernet port and configure the IP settings for your network.
2. If the is configured to automatically obtain an IP address using (DHCP), use
the S software to read the configuration to obtain the IP address.
Type the IP address into your Chrome®, Edge®, or Firefox® browser to navigate to the
web page.
The Login window appears.
3. Enter the Username:
admin (or pre-configured Username)
NOTE: If you change the Username or Password, record them.
4. Enter the Password:
fedsig (or pre-configured Password)
NOTE: The password is case sensitive.
5. Click Sign In.