30
Installing the Kit
One-Way to Two-Way Kit for DBFCB
Federal Signal www.fedsig.com
37. Install the intrusion switch (item 10) using a 3/8-inch socket.
Figure 37 Intrusion switch
38. Install the intrusion wire (item 15) on the controller board. If there is any confusion,
refer to the schematic in the DCB, DCFCB and DCFCTB Models Manual.
Figure 38 Intrusion wire
39. Install other end of the intrusion wire to the intrusion switch. Connect to COMMON on
the switch.
Figure 39 Other end of intrusion wire
