13
Testing and Training
Description, Specifications, Installation, and Operation Manual
Federal Signal
www.fedsig.com
Testing and Training
After the installation is complete, do the following:
• Test the Informer-PA and all accessories from the control point(s) to ensure it is
operating properly.
• Ensure all users are properly trained to use the system before putting the
Informer-PA into service.
• Verify all tone, voice, and text messages contain the correct content per the
emergency operating plan. Alerts should exceed the ambient sound levels by at least
10 dB to ensure they can be heard.
• Conduct testing regularly per facility safety plans to ensure the equipment remains in
working order, and operators remain familiar with the use of the equipment.
Operations
Figure 5 Informer-PA Back View with Power Supply
Input/Output Locations
Figure 6 Informer-PA Input/Output Locations
Ethernet Port (PoE)
Power Input
Audio Output Level Adjustment (Optional)
600 ohm Audio and Relay Output
RS232 Port
Rear Input
Strain Relief (x3)
Informer 2
Informer 1
Ethernet Port (PoE)
Power Input
RS232 Port
Rear Input
Audio Output Level Adjustment (Optional)
