Installation: Electrical Box Mount
Model 400 Series Lights
11
SHOCK HAZARD—DO NOT connect wires when power
is applied. Failure to follow this warning could cause
serious injury or death.
6. Connect the green wire (ground) to the 4" x 4" electrical box.
Note:
DO NOT make electrical splices within the wall/ceiling
mounting bracket.
7.
Splice the light wires and audible device wires (if applicable)
to the electrical supply wires in the electrical box.
8.
Place the assembled light and mounting bracket over the
adapter plate and tighten the two cone point set screws.
Make sure that the screws engage the two dimples in the
adapter plate.
Ceiling Mount
Model 400 Series Light can be mounted flat on a ceiling or on
a 4" x 4" electrical box. Both of these mounting methods are
variations on those methods already described. However, the
wall/ceiling mounting bracket must be attached to the lower
housing of the light. If an audible device was installed, the
mounting bracket should be attached to the lower housing of
the light.
If the bracket is already attached, disregard the instructions
in this section and refer to the Flat Surface Mount instructions
on page 7 or the Electrical Box Mount instructions on page 10.
However, if it is necessary to attach the bracket to the light, see
Figure 4 on page 12 and follow these steps:
1.
Remove the four slotted housing fastening nuts and lift the
lower housing from the light assembly.
2.
Remove the grille cover plate from the bottom of the
housing by removing the four 6-32 Keps nuts and washers
at the bottom of the housing.
