2
FDC 4, 5, 5W & 8
Issue 05 10/14
Fig 1 - Multi Tool Details
1. List of Components
Description of Parts
Qty
FDC Stove Assembly
1
Door Handle (screws into knob)
1
Multi Tool
1
Ash Pan
1
Flue Spigot Collar
1
Flue Blanking Plate
1
Spigot Collar fixing screws & nuts
3
Blanking plate M6 screws & nuts
3
Stove Operating Glove
1
2. Component Identification and Assembly
Your stove comes packed in a plywood crate. Carefully remove the straps and lift
off the upper crate. Remove any plastic packaging, open the door and remove all
the contents. THE DOOR HANDLE MAY BE PACKED ON TOP OF THE BAFFLE
PLATE
– REACH THROUGH THE TOP SPIGOT OPENING TO FIND IT. See List of
Components section and check contents carefully.
2.1 To remove the baffle plate, first remove the two stainless steel side firebox liner clips
by lifting them above the fuel retainer. Remove the two firebox side liners. Now
remove the firebox rear liner. Handle & store very carefully to one side where they
will not get broken.
2.2 Remove the front fuel retainer by lifting up and rotating until it can be lifted through
the open door of the firebox.
2.3 Now the baffle plate can be removed by lifting off its supports and bringing out
through the firebox door opening.
2.4 Fit the flue spigot collar to the top or rear outlet (as required for the installation)
using the 4 x M6 set screws and washers supplied. Use 3mm ceramic gasket
provided or fire cement to seal.
Fig 2
– FDC4, FDC5, FDC 5W & FDC8 Stove Assembly and controls
FDC5 Stove Shown