62
4.18
S
AVE
P
ROGRAM
/
A
CTIVATING
S
ENTINEL
PRV
CONTROL
For Sentinel to be able to control the PRV using the current
program settings (held by the IDT program), IDT must send the
settings to the unit, which must then store it.
Click on the “Setup
Device
” button, found
by selecting
the “setup” tab and scrolling to the bottom.
The process will proceed as described earlier in section 2.3.4. However, the installer
must now ensure that Sentinel is fully activated.
i.e.
Click on “Yes” when asked if you wish to sta
rt
controlling now.
Note:
After the unit is fully operational,
the user can still pause control
and (later) restart it without making
any further program changes.
This can be done by using the
buttons within the PRV Installation
tab
…
Click on the
“No Control” button if
you wish to pause automatic PRV
control.
Click on the
“Start control” button
if
you wish to un-pause automatic PRV
control.
Caution:
Be sure to un-pause the control before leaving the unit.
