64
When Frequency is selected, it is not possible to add any additional lines to the table;
just one exists.
The frequency is set by entering the required
time interval between call-ins.
When time is selected, additional lines will
automatically be added if a line is enabled (by
selecting “On”) using the call
-in control.
Set the time of the call-in at the end of the line.
Times can be “deleted” by selecting a line to “Off”.
Note: If no remote communication is required, set each
‘
Call in
’ drop box as ‘
Off
’
.
The protocol for sending in the data should also
be selected. This should normally be UDP for
correct operation of Sentinel2.
Note: The unit may be set to generate a message to the server, often called an alarm.
These may be set to make calls in addition to any schedule programmed here.
4.20.2
Destination
The unit needs to know details of the data destination so that it can send it to the
correct server via the internet.
The installer can either put an internet address
(IPv4)
of the server in the “Address”
field or use
a URL.
In order to route the data to the server a UDP
port-number is also required.
The server can also process messages sent via
the SMS (text message) service.
The SMS number is the destination
“mobile
phone number”
for SMS messages to reach the
server.
Note: The settings and SMS number required
for your company’s server will be
provided by your
system administrator
.
