FCA US DODGE JOURNEY 2020, Owner'S Manual

Page: 199 / 404

IN CASE OF EMERGENCY 197
3. Disconnect the bulb from the harness
connector and then connect the replace-
ment bulb.
4. Install the bulb and connector assembly
into the headlamp housing and rotate it a
quarter turn clockwise to lock it in place.
Front Fog Lamp
NOTE:
Turn the steering wheel to the right if replacing
the left front fog lamp or to the left if replacing
the right front fog lamp to allow for easier
access to the front of the wheel well.
1. Remove the fasteners retaining the front
lower wheel well access panel and remove
the access panel.
2. Remove the electrical connector from the
fog lamp housing.
Front Fog Lamp Electrical Connector
3. Squeeze the two tabs on the side of the bulb
socket and pull straight out from the fog
lamp.
4. Install the replacement bulb and connector
assembly straight into the fog lamp until it
locks into place.
5. Reinstall the front lower wheel well access
panel and fasteners.
Rear Turn Signal And Backup Lamp
The tail lamps are a two-piece design. The
tail/stop/rear turn signal lamps are located in
the rear corner body panels. The tail and
backup lamps are located in the liftgate.
License Plate Lamp
1. Push the small locking tab sticking out of
the end of the lens toward the side of the
vehicle and hold it in that position.
License Lamp
2. Insert a small flat-blade tool between the
end of the lens with the locking tab and the
surrounding housing and then pivot the tool
to separate the lens from the housing.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
CAUTION!
Never introduce leaded fuel to the tank, even
in small amounts in an emergency, as this
would damage the catalytic converter beyond
repair.
6
20_JC_OM_EN_USC_t.book Page 197