FCA US DODGE CHARGER 2021, Owner'S Manual, Page: 47 / 356

GETTING TO KNOW YOUR VEHICLE 45
For vehicles sold in Canada, rotate the
headlight switch clockwise from the parking
light and instrument panel light position to the
AUTO position for automatic headlights. Rotate
to the second detent to turn on headlight,
parking light, and instrument panel light
operation.
NOTE:

Your vehicle is equipped with plastic head -
light and fog light (if equipped) lenses that
are lighter and less susceptible to stone
breakage than glass lights. Plastic is not as
scratch resistant as glass and therefore
different lens cleaning procedures must be
followed.

To minimize the possibility of scratching the
lenses and reducing light output, avoid
wiping with a dry cloth. To remove road dirt,
wash with a mild soap solution followed by
rinsing.
M
ULTIFUNCTION
L
EVER
The multifunction lever is located on the left
side of the steering column.
Multifunction Lever
D
AYTIME
R
UNNING
L
IGHTS
(DRL
S
) — I
F
E
QUIPPED
The Daytime Running Lights will turn on when
the engine is started and will remain on unless
the headlights are turned to the on position, the
parking brake is applied, or the ignition is
placed in the OFF position.
NOTE:

For vehicles sold in Canada, the Daytime
Running Lights will automatically deactivate
when the front fog lights are turned on.

If allowed by law in the country in which the
vehicle was purchased, the Daytime Running
Lights can be turned on and off using the
Uconnect system
Ú
page 138.

On some vehicles, the Daytime Running
Lights may deactivate, or reduce intensity, on
one side of the vehicle (when a turn signal is
activated on that side), or on both sides of
the vehicle (when the hazard warning lights
are activated).
H
IGH
/L
OW
B
EAM
S
WITCH
Push the multifunction lever toward the
instrument panel to switch the headlights to
high beams. Pulling the multifunction lever
back will turn the low beams on.
A
UTOMATIC
H
IGH
B
EAM
— I
F
E
QUIPPED
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
inside rearview mirror. This camera detects
CAUTION!
Do not use abrasive cleaning components,
solvents, steel wool or other abrasive
materials to clean the lenses.
2
21_LD_OM_EN_USC_t.book Page 45