FAZUA RIDE 50 TRAIL/STREET, Assembly Instructions Manual

Page: 20 / 32

English | Assembly instructions
20
Step 5: Inserting the LOCKER adjustment plate
By screwing the LOCKER to the frame, the LOCKER adjustment plate(s) is/are braced.
Additional fixing is therefore not necessary.
→
Depending on your measurement result in Step
3 “Checking the gap dimension / measuring
existing tolerances if necessary”, place one
or two LOCKER adjustment plate(s)
(11)
on the
LOCKER and reinsert the LOCKER into its seat on
the e-bike frame.
11
→
Tighten the locking screws (RIDE 50 screw lock
mount)
(8) with the Torx screwdriver T20.
1.8–2.2 Nm
8
Step 6: Inserting the Ride 50 lock cylinder
→
Insert the Ride 50 lock cylinder cover (10) supplied
with the LOCKER into the corresponding opening
on the frame.
→
If necessary, use the Ride 50 locker plug to close
the hole in the downtube.
10
5.2 Dismantling the LOCKER from the frame
→
Loosen the locking screws (RIDE 50 screw lock
mount)
(8) on the LOCKER with the Torx screw-
driver T20.
→
Remove the LOCKER from the frame through the
holder for the DRIVEPACK.
8