Fayat Dynapac F80W, Operating Manual

Page: 59 / 198

53 F80W
OPERATING MANUAL
2.2.2 Preservation and storage of the machine
for 1–2 months
Before storing the machine, clean and wash the whole machine.
Before putting the machine out of operation, start the machine
to warm operating fluids up to the operating temperature. Then
refill the operating fluids up to the levels specified in this Oper-
ating Manual.
Before preserving and storing, clean the machine from coarse
impurities and wash.
Wash the machine only in areas with intercepting traps
to intercept the contaminated water and detergents.
Park the machine on a flat solid surface in a safe area
when there is no danger of damage to the machine by
a natural disaster, e.g. landslides, floods and fire.
The following tasks must be performed first on the machine:
• stop the machine and turn off the engine
• turn off the battery disconnecter
• the machine hopper must be closed and locked
• the machine screed must be placed horizontally on a flat
and solid surface
• the protective roof of the machine must be locked in the
highest working position or adjusted in the lowest working
position
• protective covers of the individual instruments and machine
covers must be locked
• if the machine is equipped with a gas bottle, the gas bottle
must be removed from the machine and stored in a special
area.
Then it is recommended to perform the following tasks:
• repair damaged paintwork,
• service lubrication points according to instructions stated in
the manual,
• check the pressure in tyres if the machine is equipped with
wheels; protect the tyres from direct sunlight,
• check that the water tanks are drained if they are on the ma-
chine,
• check that the coolant has the desired antifreeze properties,
• check the batteries for charging and recharge them if re-
quired according to instructions of the manufacturer
• apply chemical preservatives on chromium-plated surfaces
of piston-rods,
• we recommend you to protect the machine from corrosion
by spraying a chemical preservative, particularly in areas
where corrosion can occur.
If you treat the machine as above described, it is not necessary
to prepare the machine in a special manner before it is put into
operation again.
It is only necessary to wash the machine to remove applied
chemical preservatives.
Wash the machine only in areas with intercepting traps
to intercept the contaminated water and detergents.