Fayat Dynapac F80W, Operating Manual

Page: 102 / 198

96 F80W
2
3
451090A
43
44
51
52
451091A
2.6 Operation of the screed
2.6.3 Setting the paving width
The machine is equipped with a left (43) and right (44) screed
extension frame for setting the paving width.
The required paving width can be set using the controls (2) and
(3) on the dashboard.
The basic screed width is 800 mm (31.5 in), and each of the ex-
tendible screed extension is 250 mm (9.8 in) wide. The adjust-
able range of the paving width corresponds to the total width
of both extendible screed extensions and amounts to 500 mm
(19.7 in). The paving width can be adjusted in a maximum to
minimum range value.
The paving width in the standard model of the machine is:
• Minimum paving width without reduction plates 800 mm
(31.5 in)
• Maximum paving width without reduction plates: 1,300 mm
(51.2 in)
Paving width with reduction plates is:
• Minimum paving width with reduction plates: 250 mm
(9.8 in)
• Maximum paving width with reduction plates: 750 mm
(29.5 in)
Paving width with mechanical extension is:
• Minimum paving width with mechanical extension:
1150 mm (45.3 in)
• Maximum paving width with mechanical extension:
1650 mm (65 in)
Setting the paving width:
Procedure for setting the required paving width on the left
side of the screed:
• To increase the paving width on the left side, turn the pav-
ing width switch (2) to the left and hold it.
• To release the paving width switch (2), lock it back to the
middle position and the screed stops in the required posi-
tion.
• To decrease the paving width on the left side, turn the pav-
ing width switch (2) to the right and hold it.
• To release the paving width switch (2), lock it back to the
middle position and the screed stops in the required posi-
tion.
• Check the required setting of the paving width on the left
side by checking the position on the left paving width in-
dicator (51).